http://americanwoodworker.com/forums/29052.aspxenCommunityServer 2008.5 SP1 (Debug Build: 31106.3070)http://americanwoodworker.com/forums/thread/4472.aspxMon, 16 Nov 2009 15:13:26 GMTf5d4cb8b-9fb3-4c0a-bdc0-3814c4db8d93:4472japeltier0http://americanwoodworker.com/forums/thread/4472.aspxhttp://americanwoodworker.com/forums/commentrss.aspx?SectionID=29052&PostID=4472<p>Best I can help is the following link:</p> <p><a href="http://www.woodmagazine.com/woodworking-plans/drilling/bore-vertical-holes-with-scrap-stock-jig/">http://www.woodmagazine.com/woodworking-plans/drilling/bore-vertical-holes-with-scrap-stock-jig/</a></p> <p>&nbsp;</p> <p>Good Luck</p><div style="clear:both;"></div>http://americanwoodworker.com/forums/thread/4470.aspxSun, 15 Nov 2009 21:24:14 GMTf5d4cb8b-9fb3-4c0a-bdc0-3814c4db8d93:4470tomrbensin0http://americanwoodworker.com/forums/thread/4470.aspxhttp://americanwoodworker.com/forums/commentrss.aspx?SectionID=29052&PostID=4470<p>I have a 4 foot long newell post and need to bore a 7/16 hole, 3 inches deep.&nbsp; How do I ensure the hole</p> <p>is straight and parallel to the post.&nbsp; If it was bored crooked, it may not look straight after installation.&nbsp; I have a floor</p> <p>&nbsp;drill press but at a loss on how to mount it so that the post is straight and in line with the press.&nbsp; Any help would</p> <p>be appreciated.&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; <a href="mailto:tomrbensin@aol.com">tomrbensin@aol.com</a></p><div style="clear:both;"></div>