http://americanwoodworker.com/forums/2421.aspxenCommunityServer 2008.5 SP1 (Debug Build: 31106.3070)http://americanwoodworker.com/forums/thread/4202.aspxThu, 22 Oct 2009 21:48:12 GMTf5d4cb8b-9fb3-4c0a-bdc0-3814c4db8d93:4202American Woodworker Editors0http://americanwoodworker.com/forums/thread/4202.aspxhttp://americanwoodworker.com/forums/commentrss.aspx?SectionID=2421&PostID=4202<p>Check out this article on making doors: http://americanwoodworker.com/blogs/techniques/archive/2009/02/22/making-cathedral-doors.aspx<br /><br />It&#39;s for cathedral style doors but the approach is pretty much the same with square doors except you use the router fence to guide the raised panel rather than a template.<br /><br />Hope this helps.<br /><br />Happy routing.</p><div style="clear:both;"></div>http://americanwoodworker.com/forums/thread/4137.aspxFri, 16 Oct 2009 10:40:48 GMTf5d4cb8b-9fb3-4c0a-bdc0-3814c4db8d93:4137Paul D Andrus0http://americanwoodworker.com/forums/thread/4137.aspxhttp://americanwoodworker.com/forums/commentrss.aspx?SectionID=2421&PostID=4137<p>Hello everyone here. I just joined a few minutes ago.</p> <p>I&#39;m&nbsp; a beginning woodworker, and need lots of advice. My first issue is using a 3.5&quot; ogee bit for raised panel doors I am making. Can someone walk me through it? I have a PC 3.5 HP fixed router in&nbsp; my base, and have been successful on small projects; (dadoes, edging etc) but now I need advice on how to use it for the raised panel doors. I would appreciate all the advice I can get, and then some!</p> <p>Thanks to everyone here, and I&#39;m sure I will enjoy this new site.</p> <p>&nbsp;</p> <p>Paul</p><div style="clear:both;"></div>