Technique Questions

Re: Techniques

chad stanton — Thu, 28 Jun 2012 11:02:58 GMT

Hello,

Your question is a good one. My friend's son wrote a book on cove cutting. I've gone through it and it doesn't mention anything about the type of blade. However i would think a good sharp combination blade would be what you are looking for. YOu are cutting a cross cut and rip cut at the same time. The techiniques works great, just make sure you only raise the blade an 1/8" for each pass and listen to the sound of the saw when cutting.

Chad Stanton

Re: Techniques

MinnWorker — Wed, 11 Apr 2012 03:15:41 GMT

American Woodworking Mag had an excellent article on just this subject:

http://americanwoodworker.com/blogs/techniques/archive/2009/09/24/crown-molding-on-the-tablesaw.aspx

My personal experience is no matter what you use, it is very time consuming followed by a lot of sanding. If you find a better way, let us all know.

Techniques

Woodlock — Tue, 28 Feb 2012 13:57:47 GMT

What is the best 10'' blade to use when making cove moulding on a table saw?