Subscribe to Print Subscribe to Digital Give as a Gift Renew Now Subscriber Services
Free Product Guide >>
Hello,
I am just about finished with a gut job on my kitchen. I installed maple cabinets that have crown molding going up to the ceiling. I have a void above my sink that I would like to continue molding to connect two sets of cabinets. The problem I ran into is that the section where the void is, is about 3/4 inch lower than the rest of the ceiling. I couldn't get the molding to match up without huge gaps. The only thing I can figure out would be to cut away the ceiling but then the molding will lose 3/4 inch of the profile and I doubt it would look right. This is the last thing I need to do to complete my kitchen and have chopped up too much of the expensive maple molding trying to get this right.
Any suggestions would be extremely appreciated. I am an above average diyer at best.
Post a couple pictures the problem. It will make suggestion an answer easier.
To post a photo, click on the film strip icon in the menu bar when you respond.
Thanks,